Page 2 of 2

Re: Programming a new Remote Keyless Entry Fob?

Posted: Thu Aug 29, 2019 4:55 pm
by donarudo
That's great to hear. I am in Seattle too, with the same problem. Which dealer did you go to, may I ask?

Re: Programming a new Remote Keyless Entry Fob?

Posted: Fri Aug 30, 2019 7:37 am
by TheLondonBroiler
Td911 wrote:
Wed Aug 07, 2019 4:11 pm
I purchased a 2016 Spark LT1 2 weeks ago from a Seattle Chevy dealer and I needed a 2nd key fob made. The parts department ordered it and it came in a week. They cut the key fine but when they tried to program the fob the car wouldn’t go into programming so they had to connect the car to their computer and and it went fine. The service advisor said some of the Spark ev fobs need to be programmed that way. $62 for the fob, $68 to program it., but I got the salesman to cover the programming part. Done and it works.
Good to hear. Even @ $130, that seems like a bargain compared to what most charge. I discovered that the programming procedure GM outlined in the manual is actually impossible due to a hardware limitation, which I outlined in a similar thread on this forum.

Re: Programming a new Remote Keyless Entry Fob?

Posted: Thu Sep 05, 2019 10:30 am
by Mesasand
I’ve contacted several third party locksmiths and nobody will touch it. From all my research it appears the fob can only be programmed by a Chevy dealer. My local Buick dealer can’t even do it. It must be a Chevy dealer.

Re: Programming a new Remote Keyless Entry Fob?

Posted: Thu Dec 12, 2019 7:29 am
by two20142lts
Even thought the manual gives instructions it does not work only a dealer or level scan tool will work. I got the dealer to do it for 50.00